» gas

Rust Removal From A Motorcycle Gas Tank Using Electrolysis

A simple Electrolysis set up using a PC power supply as the power source, a wire hanger as the sacrificial anode and a mixture of water and Sodium Carbonate also known as Washing Soda/Laundry Soda. You can make your own Sodium Carbonate by heating up baking soda in the oven for an hour or so, above 300 degree Fahrenheit (149 degree Celsius). I read that some people are you using oxyclean since the active ingredient is Sodium Carbonate. The solution in the tank is a mixture of 5 gallon of water and 1/2 cup of Sodium Carbonate. I topped the tank off, put in the sacrificial anode, connect power to the anode, ground wire to the tank and turn on the power. You should start to see bubbles if it is working right. Make sure not to let the anode touch the gas tank. Also make sure you do this in a well ventilated location because the reaction will release Hydrogen gas and any spark might cause an explosion. I let it do its thing for about 20 hours and after checking the tank looked like it did a really good job. It looked liked all the rust was gone but I decided to do again just incase i missed anything.

Duration : 0:1:34

Read the rest of this entry »

Technorati Tags: "Rust, 200, 200T, ATX, cb, CB200, CB200T, computer, electrolysis, from, gas, honda, Motorcycle, PC, Power, removal, SUPPLY, tank, using

Posted on March 7th, 2011 by admin and filed under Gas Tank Motorcycle | No Comments »

How to clean a Ninja 250 motorcycle gas tank with Vinegar. Part 4

How quickly the Vinegar attacks. Skip the darness and go to 1:20

Duration : 0:3:49

Read the rest of this entry »

Technorati Tags: "Rust, gas, tank

Posted on March 2nd, 2011 by admin and filed under Gas Tank Motorcycle | 1 Comment »

Top 10 Bestselling Motorcycle Gas Tanks – review

motorcycle Gas Tanks

01…Clarke 11326-01 ATV Gas Tank for Honda TRX250X 87-88-91

http://www.amazon.com/gp/product/B003HC8DOI?ie=UTF8&tag=philwebdevelo-20&linkCode=as2&camp=1789&creative=390957&creativeASIN=B003HC8DOI

02..2003-2007 KTM 450EXC: IMS GAS TANK 3.1 GALLONS – NATURAL

http://www.amazon.com/gp/product/B002FDL9IM?ie=UTF8&tag=philwebdevelo-20&linkCode=as2&camp=1789&creative=390957&creativeASIN=B002FDL9IM

03…Clarke 11393-02 ATV Gas Tank for Honda ATC 350X 85-86

http://www.amazon.com/gp/product/B003HC8ALO?ie=UTF8&tag=philwebdevelo-20&linkCode=as2&camp=1789&creative=390957&creativeASIN=B003HC8ALO

04…Clarke 11311-01 ATV Gas Tank for Honda TRX 200SX 86-88

http://www.amazon.com/gp/product/B003HC8DHK?ie=UTF8&tag=philwebdevelo-20&linkCode=as2&camp=1789&creative=390957&creativeASIN=B003HC8DHK

05…Clarke 11414-01 ATV Gas Tank for Kawasaki 300 Bayou 86-88

http://www.amazon.com/gp/product/B003HC8DQ6?ie=UTF8&tag=philwebdevelo-20&linkCode=as2&camp=1789&creative=390957&creativeASIN=B003HC8DQ6

06…Biker’s Choice GAS TANK, XL SPORTS-TOUR 011483

http://www.amazon.com/gp/product/B000GZTLVI?ie=UTF8&tag=philwebdevelo-20&linkCode=as2&camp=1789&creative=390957&creativeASIN=B000GZTLVI

07…Clarke 1340 ATV Gas Tank for Honda Honda TRX 250R all Years

http://www.amazon.com/gp/product/B003HC8DRA?ie=UTF8&tag=philwebdevelo-20&linkCode=as2&camp=1789&creative=390957&creativeASIN=B003HC8DRA

08…1997-2007 KAWASAKI KLX300: ACERBIS GAS TANK 3.7 GALLONS – GREEN

http://www.amazon.com/gp/product/B001TXDGUS?ie=UTF8&tag=philwebdevelo-20&linkCode=as2&camp=1789&creative=390957&creativeASIN=B001TXDGUS

09…Brand New Honda Rebel/CMX 250 Gas Tank with Lock Set(Black/Silver)

http://www.amazon.com/gp/product/B000V22X0W?ie=UTF8&tag=philwebdevelo-20&linkCode=as2&camp=1789&creative=390957&creativeASIN=B000V22X0W

10…2005-2009 HONDA CRF450X: IMS GAS TANK 3.2 GALLONS – NATURAL

http://www.amazon.com/gp/product/B002FDNSIG?ie=UTF8&tag=philwebdevelo-20&linkCode=as2&camp=1789&creative=390957&creativeASIN=B002FDNSIG

Duration : 0:1:26

Read the rest of this entry »

Technorati Tags: 10, Bestselling, gas, Motorcycle, review, tanks, top

Posted on February 18th, 2011 by admin and filed under Gas Tank Motorcycle | No Comments »

BIKE IS FOR SALERemove the Stock Seat & Install Danny Gray Solo Seat on Harley Davidson Rocker C

**THIS BIKE IS FOR SALE***SEND MESSAGE IF INTERESTED*** Click Here: to Purchase Your Shaving Products: http://www.ShaveNation.com/products
How to Remove the Stock Seat and Chrome Flip Seat Support Assembly and Install a Danny Gray Solo Seat on a Harley Davidson Rocker C Motorcycle 2008 2009 2010 2011 from Start to Finish To Remove the Large Gap Between the Rear Fender and the Seat.
Tutorial, instructions, and directions.
Misc: Remove Bolts apply loctite as needed. Remove Seat. Fill unused holes with bolts, grommets, or silicone. Use Heat shrink to splice and seal wires, wiring. Use penetrating agent and or wd40 to loosen bolts or hammer and screwdriver in counterclockwise direction. Battery compartment below seat. 8 9 10 11 model year years.

Duration : 0:7:16

Read the rest of this entry »

Technorati Tags: "Remove, 2-up, air, anarchy, assembly, bob, Brake, brush, burnout, chop, CHOPPER, chrome, classic, clutch, convertible, Custom, Danny, Davidson, direction, dyno, engine, exhaust, factory, Fatboy, fender, flip, foor, gap, gas, Glide, Gray, Grey, harley, hd, Head, heartland, Install, instruction, light, low, lower, lowered, new, of, oil, paint, passenger, peg, pillion, REAR, replace, review, ride, rider, ROCKER, seat, solo, sons, sound, stock, tank, tire, torque, transmission, tutorial, Ultra, wheel, wide

Posted on February 10th, 2011 by admin and filed under Motorcycle Seat | 9 Comments »

painting a motorcycle tank part one

part one, remove emblems, sand all blemishes with sand paper, apply bondo to dings, sand smooth. TAKE YOUR TIME, it pays off

Duration : 0:3:51

Read the rest of this entry »

Technorati Tags: gas, Motorcycle, one, paint, painting, part1, tank

Posted on January 24th, 2011 by admin and filed under Gas Tank Motorcycle | No Comments »

Draining fuel tank

Draining the fuel tank of a Suzuki GS650G by setting the petcock to PRI which drains it out using gravity instead of ON which uses the vacuum from the carbs. I am draining the fuel tank because I am going to replace the fuel valve and petcock assembly.

Duration : 0:0:14

Read the rest of this entry »

Technorati Tags: drain, fuel, gas, Motorcycle, suzuki, tank, valve

Posted on January 9th, 2011 by admin and filed under Gas Tank Motorcycle | No Comments »

Honda Motorcycle Racing Fuel Cap OEM Direct Replacment Gas Cap

Buy @ http://www.amazon.com/dp/7462847671/?tag=chittiv3-20
Technical Details:Enhance the look with this lightweight fuel cap * OEM Fit and Easy Replacement * CNC machined made with aircraft grade 6061-T6 solid billet aluminum that has no porosity and is very high in corrosion resistance * Direct bolt on; Easy installation, no modification required * HIGHEST QUALITY AND UNIQUE STYLE, OEM DIRECT REPLACMENT

Duration : 0:0:21

Read the rest of this entry »

Technorati Tags: Cap, demo, Direct, discount, fuel, gas, honda, Motorcycle, oem, racing, Replacment, review, unboxing

Posted on January 9th, 2011 by admin and filed under Motorcycle OEM | No Comments »

Kawasaki Motorcycle Racing Fuel Cap OEM Direct Replacment Gas Cap

Buy @ http://www.amazon.com/dp/B002EWZJHQ/?tag=chittiv3-20
Technical Details:Enhance the look with this lightweight fuel cap * OEM Fit and Easy Replacement * CNC machined made with aircraft grade 6061-T6 solid billet aluminum that has no porosity and is very high in corrosion resistance * Direct bolt on; Easy installation, no modification required * HIGHEST QUALITY AND UNIQUE STYLE, OEM DIRECT REPLACMENT

Duration : 0:0:21

Read the rest of this entry »

Technorati Tags: Cap, demo, Direct, discount, fuel, gas, kawasaki, Motorcycle, oem, racing, Replacment, review, unboxing

Posted on January 6th, 2011 by admin and filed under Motorcycle OEM | No Comments »

Part 6of6: Motorcycle Rust Removal and Resoration using a Kreem Kit Part 6 of 6; The liner

Here is a great one liner: Kreem Koat it! This will fix any metal tank if it will fix this one! After carefully removing all rust and debris from this Honda tank, it is ready for the tank liner. Use in a very well ventilated area and keep the tank moving in a rolling pattern for 5 minutes even after the excess is poured out! This will prevent any puddles from forming. You want a uniform coating of Kreem liner in the tank.